...candy when started it does not move on to next program found problem no power going to motor at back of dial ,took dial apart to check connections all good , power is going to circuit board at dial ...
Question about AQ130 Front Load Washer
...Candy Aquaviva 1300 please? Hi, I have just moved into a new house and this washing machine/Dryer was already there, I can use the washing part no problem but when it comes to the dryer i havent a ...
...machine so dont really want to buy another!!! try to wash clothes with pre-wash program i had the same problem with marks on the clothes , when i found out later that the water seal on the drum had ...
machine starts but then makes a continuous churning sound as if it is stuck in the program. If it is not washing the dishes, make sure the door is closed correctly. If it still makes that noise, check
Question about CNW136 Front Load Washer/Dryer
it stops mid cycle both the 90 duration button and stain vanish button flash i had repair man and he said it was the program board which was replaced but it is still the same exact same problem is ...
...Candy CMW 136, Type LCE2 has 2 major problems: 1# It starts to spinn out of control in the middle of the washing cycle (filled with water). After a couple of attempts to make this furious spin it ...
Question about CNW136 Front Load Washer/Dryer
...candy-grando-washing-machine-series-fault-codes.html hope that helps I bet that you have not cleaned out pockets, coins, tissues etc are all good reasons to want to buy a new machine. Either the pump ...
Candy CFD 612 problem After a wash, the waste water has not drained and attempting to switch off and re-program will not drain the water have you checked the filter is the mach niosy if you pull the ...
Question about CNW136 Front Load Washer/Dryer
...Candy, so have I with mine.it is mostly when I am starting a drying program, that she starts washing again. Then I : turn the machine off Wait 3-5 minutes Turn on emptying Wait 3-5 minutes Turn on ...
...Candy washing machine it's barely 1 year old and recently when the program its finished instead of written "End" on the screen is showing E09 than I have to change the program let say I put spin for ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions