Questions & Answers for: cam shaft positioning sensor 2001

...cam position sensor. Most likely a fault or bad sensor or bad sensor reading. One test was to clear it and see if it reappears. Because if it is an ongoing problem, it will trip it again. The check ...

...one to replace . My bet is on the crankshaft pisition sensor but it could be the konck sensor or the cam shaft pisition or ever a bad gear at the bottom of the disturbutor shaft. FIND OUT THE ...

...monte carlo ss idles up three our four notches been had idle control valve replaced go to your local auto parts store and they should have a scanner but it sounds like eather the Throttle Position ...

cam shaft and crank shaft position sensors. If they are good then it is most likely the engine control module. You check the sensors by ohming across the two wires that go to them. Also make sure they

...side along with the plastic coverings for the engine. Remove the bolt holding the pulley Use a pulley puller to pull the crankshaft pulley off. Remove the sensor on the right side if the of the

How do I install a crank shaft position sensor for a 1998 Monte Carlo z-34 with a 3.8 engine? chevy 3 8 crank shaft sensor YouTube

How do I change out a crank shaft position sensor for a 1998 Monte Carlo Z-34 with a 3.8 engine? chevy 3 8 crank shaft sensor YouTube

...Carlo 3400 Hi Zachary,here's a link to a repair guide showing you where your Crank Shaft Position sensor is and how to replace, Repair Guides Components Systems Crankshaft Position Sensor AutoZone ...

how to change knock sensor on 2001 Monte carlo where are the knock sensors on 2001 Monte carlo 3.8 It is located under the intake manifold. The manifold has to be removed to access the sensor.

The cam sensor has three wire connector. The cam sensor appears to be held on with bolt. As far as more info concerning removal, I'd have to look at the vehicle. That's all the info, I have. good luck