Questions & Answers for: Pioneer cable system

...System Cable" wires that connect the Media Reciever to the TV. The HDMI slots are not even shown in the owners manual but it's clearly stated on the Media Reciever. The HDMI does plug in from the ...

system to a comcast digital cable box via the instructions and can't get any sound except the radio. I've use spdif cable too. I've used RCA Jacks from the audio out on the cable box to the sat /tv in

I'm trying to hook my htd-510 to our toshia Hd and cable Without knowing what model Toshiba you have I have to guess that it has an audio output on it. If it does then you connect the audio out on the

..... need to connect my tv audio through my pioneer 5.1 home theater.I was using normal video audio cable ...shall i use component cable???pls advice "Component" cable refers to the 3-wire hi-def ...

...system but missing a cable that has about 9 prongs.. round tip. not working pioneer htv c1 You can probably find the cable on eBay. If not, a Pioneer service center can order one for you, or you can ...

Need the cables for dv77 Which cable are you looking for? HDMI, optical, coaxial, A/V cable Someplace like Radio Shack or any electronics retailer will have every cable you might need.

...cable. can the system be connected via the optical TOSLINK cable No. The Toslink cable would only carry the audio portion and not the video. That's why the HDMI cable and it's related firmware were ...

...is it on, is it on mute , is the volume turned down , was it working then stopped, are the audio cables in properly either hdmi or optical try pulling them out and putting them back it sometimes ...

...system Receiver? Turn the TV and receiver off and back on. This is called "power cycling" the devices. Check the menu settings to make certain the TV is still sending a sound signal out to the ...

...system, including the power cable, audio cables, and any other cables that may be required for your setup. Reset the system: Unplug the system from the power source, wait for a few seconds, and then ...