...power cable from printer and from the wall outlet.Press and hold ON buton for 30-60 seconds. PARTIAL RESET:-Unplug the printer power cable while its ON, press and hold # and 3 button and connect the ...
Question about OfficeJet 6310 All-in-One Printer (Printer/Scanner/Copier/Fax) w/USB Printer Cable , Retail
...power cable from the back of the machine while the machine is powered on. Reconnect the power cable after 10secs than the machine should reboot by itself. This resolve your issue. Else try to use a ...
...cable and power cable ). 2.) Check for any obstructions in side the printer. 3.) While the printer is off and cables are unplugged., press and hold the on button for 10 sec., release after 10 sec., ...
Question about Stylus CX6400 All-In-One InkJet Printer
power cable and usb cable ). 2.) Check if there's any obstructions inside the printer. 3.) While the printer is off and unplugged., press and hold the on button for 10 sec.., release after 10 sec. and
Question about J3680 Officejet All In One Printer
...power cable from the back of the printer and from the walljack wait for 30 seconds then replug the power cable to the wall out let and then to the printer. Power Drain Remove the cartridges from the ...
power cable from backside of the printer and from wall outlet. Press and hold the Power button for 60 seconds. Connect the cable and turn ON the printer. Partial Reset Remove the power cable from back
Question about PSC 1315 All-In-One InkJet Printer
...power cable and also the wall jack, power on (don't connect the usb cable). While the printer boots up, keep pressing power button several times. Leave it for few minutes and again switch off. Now ...
Question about Photosmart C6100 All-In-One Printer
...power cable from backside of the printer and from wall outlet. Press and hold the Power button for 60 seconds. Connect the cable and turn ON the printer.Partial Reset Remove the power cable from back ...
power cable/ Camera and PC usb cable. Disconnect the power cable from wall outlet. Press and hold the power button for 30 seconds. Connect the printer power cable and turn ON.Solution 2: Printer Reset
...power cable and interface cable USB or Parallel from the printer. Then, after about a minute, connect the power cable first, and see if your printer is powering up. If not, the problem is more likely ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions