Questions & Answers for: buttons stay lit

Question about Corded Phone IBM412CID

1 Answer

Redial Button on IBM-412CID stays lit We have 5 phone systems on a 4-line plan. I have 2 of the systems that the Redial Button stays lit. I have reprogrammed all 5 phones and these 2 still have the ...

Ad

stay lit even after replacing thermal coupl I asked a question the other day and my wife deleted the return email before I could read it. So I'm going to ask again. My Kenmore propane hot water heater

Ad

...is staying lit up even in all the other modes (2HI, 4HI, 4LO). What's keeping the AUTO 4WD button to stay lit up ?? the transfer case module is bad it is bolted to transfer case above front drive ...

Question about Corded Phone IBM412CID

2 Answers

stay lit your thermocouple needs to be replaced. they are available at any hardware store. If you can get it to stay lit without holding the button, you have an airflow issue. There';s a draft blowing

Question about Corded Phone IBM412CID

3 Answers

...buttons do I need to press to make the display stay lit? I can't find it in the manual anywhere... Same thing happened to our Kenmore range and I found a solution on the web about fixing this problem ...

Question about (GA200209) Stainless Steel Open Flame Patio Heater

1 Answer

...stay lit and heater will not light pilot will not stay lit when button is released.If button is held on so pilot stays lit, it will go out when unit is turned to on and no heater flame results. ...

Question about Laars Lite 2 Pool Heater 250,000 Btu / Propane Gas

0 Answer

...down button light under where small silver line goes under while holding down button when lit keep holding for about a minute then turn to on should stay lit if wont stay lit need new pilot ...

...stay lit unless you hold down the gas button constantly... My ready heater 30k BTU propane heater wont stay lit unless you hold down the gas button down constantly...Normally you would hold it in ...

stay lit. My 6 gallon hot water heat on my 2007 camper won't stay lit, I go and light the pilot light and it lights but I turn the gas up and it blows out please help the thermal couple is likely bad

...stay lit again. Point the remote toward your TV and press the "Power" button on your remote, holding it down until the TV turns off. Do not press "Power" again after the device turns off. Press the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Lands Phones Experts

Cindy Wells

Level 3 Expert

6688 Answers

k24674

Level 3 Expert

8093 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Lands Phones Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...