Questions & Answers for: Harley Davidson FLSTC Heritage Softail Classic bushes for a starter motor

...relay under your seat. take a jumper wire from your batter positive to the starter you will be touching the large copper stud under the rubber grommet. if the motor kicks in its your starter

...starter shaft and turn the motor over? Sounds to me like the "overrunning clutch" is bad. You'll have to remove the starter and disassemble it. The starter drive is part #31663-90 according to the ...

...starter motor. Make sure it moves in and out freely. There is a large spring on the other end that is supposed to push the plunger back towards the plate after the engine starts. If the starter does ...

how to install rod bushings on a harley , 98 softail 1340cc. Replacing rod bushings is not a difficult job but you must have some special tools if you're going to do it with the crank assembly still ...

...starter makes a grinding noise and will not turn the motor It could be any number of things but the most likely in my opinion is that you have a bad "over running clutch" or "starter clutch" in your ...

...starter motor and solenoid. Lubricate the solenoid and dog wheel and reassemble. That should fix your problem. Reinstalling the solenois, can sometimes be a bit fiddly. Take notice when removing it ...

...starter motor spinning but the engine is not turning over, your starter clutch, sometimes called the "overrunning clutch", is bad. Try this site for your starter breakdown. http://www.bikebandit.com ...

starter motor what are the signs that my starter motor is faulty where is comment box

...starter motor. I probably has either burned out brushes or the commutator is severely pitted and the brushes aren't getting juice into the armature. When you click it a hundred times, the starter ...

...starter turns motor over in wrong dirction and continues t run WHAT???? How are you sure it is the wrong direction? Anyhow, it sounds like the voltage wires are reversed. DC motors will reverse when ...