...inside the burner box, you should see a rod that extend into the flame. Sand this rod with sand paper and try to start the furnace again. if this does not work, replace this part. Thx, Peanut ...
...burner turns off. After the igniter and burners repeat this about 2 times the heater shuts down by it's self, even when the temp gauge has not reached the temperature setting. The gas valve is not ...
Question about 10AJA6001AH Air Conditioner
...I would suspect the thermocouple. It detects the flame to prevent gas from pouring out of an unlit burner. If it malfunctions, the control thinks the burner didn't light and shuts down for
Question about 10AJA6001AH Air Conditioner
...flame of a burner. There will only be one wire to it. It sometimes collects carbon and may need to be cleaned. The circuit board only allows a very few seconds for the flame to travel from the pilot ...
...burner (bad flame spreader, dirty flame spreader, more bad burners), the flame safety sensor does not detect flame (dirty or bad flame spreader, bad flame sensor, broken wire, bad control), or the ...
fast goes out ? Clean the flame rod which is located in the flame pattern of the last burner that ignites. On wiring diagram it may be marked FP for flame proof and will have only one wire going to it
...your flame sensor is probably dirty. Your flame sensor is a rod that sits on the end of your burners to make sure all furnace jets fire if it is dirty it will cycle offf and on fore 3 or 4 ...
Heater only blows cold air. I have a Weather King Heater and it only blows cold air the burners will fire for about 2-10 seconds and then it goes out and does it for 5 times You need to clean or ...
...burner right at the flame sensor can block the micro signal back to the board. I am sorry I can't remmember the light codes. There should be sticker on the panel with the wiring diagram that show the ...
Question about 10AJA3001AH Air Conditioner
...burner flame and will keep the Furnace running, what happens is the rod builds up oxidation and then cannot sense the burner flame and will shut the burners down and keep repeating. Just remove the ...
Usually answered in minutes!
91 Questions
97 Questions
82 Questions
79 Questions
37 Questions