Question about Laars Lite 2 Pool Heater 125,000 Btu / Propane Gas
...because of poor burner flame characteristics.with top off,turn htr on and look straight down into unit. you should be able to clearly see burner flames between fins. if not remove exchanger and ...
Question about Laars Lite 2 Pool Heater 250,000 Btu / Natural Gas
Burner cycles on and off within 2-5 seconds. What could the problem be? Model Teledyne Laars LLD250N Sounds like the flame sensor. If the sensor doesn't see a flame, it shuts off. Good luck...Lee
Question about Laars Lite 2 Pool Heater 325,000 Btu / Natural Gas
pool pilot keeps tripping,what might be the problem ? One of the most common problems will be the flame sensor. If it doesn't sense the flame, it shuts down the burner. Good luck...Lee
Question about Laars Lite 2 Pool Heater 250,000 Btu / Propane Gas
flame shooting out the front of boiler flames shooting out the front of boiler You will need to remove your burner tray and clean the burners and make sure their are no rat nests. While you have it ...
Question about Laars Lx Pool Heater / 400,000 Btu / Propane Gas
...burner fires up a couple more times but shuts soon after with an AGS error. What could be the problem? The burners are clean and the pool filters have just been replaced. This error is Automatic Gas ...
Question about Laars Lite 2 Pool Heater 250,000 Btu / Natural Gas
flame sensor or a bad burner graound... the gas valve porves the flame by passing a very small current through the pilot flame... yes flame does conduct electric...if the sensor is dirty or bad or the
Question about HEAT EXCHANGER ASSEMBLY, DP-350 - 10403602
...flame rectification. This could be caused by a dirty flame sensor, poor ground to burner, faulty ignition module, improper venting, inadequate combustion air, dirty burners, or clogged heat
pilot comes on then burners fire up with good flame for about 1-2 min then something starts clicking and burners start to loose flame then i can see pilot start to flicker then no flame or pilot You ...
Question about HEAT EXCHANGER ASSEMBLY, DP-350 - 10403602
BLUE PRINT FOR A TELEDYNE LAARS MODEL NO ESC250P I took all the burners out and got all dust and rust and re aligned the burners and made sher that the ignitor was working. it was. so it wont stay lit
Question about Laars Lite 2 Pool Heater 250,000 Btu / Natural Gas
Flame Sensor, per se, it works in about the same way. As you hold down a "Pilot" button or a gas valve knob in the Pilot position, you are manually keeping a pilot valve open to provide fuel through a
Usually answered in minutes!
4 Questions