gas burners ignite then shut down Hello We have a ruud central heat furnace and it turns on then shuts down after 20 seconds.hope u can help .thanks I need your model number to be sure, but I sounds ...
...burner (bad flame spreader, dirty flame spreader, more bad burners), the flame safety sensor does not detect flame (dirty or bad flame spreader, bad flame sensor, broken wire, bad control), or the ...
...flame of one burner. It will have only one wire going to it. That is the flame probe. You can scrub it with one a Scotch Brite pad or sand paper to get the carbon off of it. Check all connections at ...
...flame on a burner. The computer allows only a second or two for the all burners to lite and to get to the flame rod. Check the flame travel from burner to burner. You may have to clean the burners, ...
...burner (bad flame spreader, dirty flame spreader, more bad burners), the flame safety sensor does not detect flame (dirty or bad flame spreader, bad flame sensor, broken wire, bad control), or the ...
...burner (bad flame spreader, dirty flame spreader, more bad burners), the flame safety sensor does not detect flame (dirty or bad flame spreader, bad flame sensor, broken wire, bad control), or the ...
...flame from burner to burner. Pull out all burners and with a paper clip, clean out all the holes. Look at the base where the burners go for a trough. This also must be clean and free of debris. If ...
Question about Matching Split Air Conditioner
...burner (bad flame spreader, dirty flame spreader, more bad burners), the flame safety sensor does not detect flame (dirty or bad flame spreader, bad flame sensor, broken wire, bad control), or the ...
Question about Matching Split Air Conditioner
the hot surface igniter (glow stick) may be only for lighting the pilot, which then ignite the main burners. The flame has to be proved before the gas valve opens for the main burners. This is done by
Question about Matching Split Air Conditioner
...This will allow the gas to run across evenly so the flame will hit each burner and not build up gas and blow like you are experiencing. Reassemble and run test with gas & power on. Good ...
Usually answered in minutes!
713 Questions
254 Questions
136 Questions
135 Questions
72 Questions