Questions & Answers for: Mitsubishi bump top

...bump or recently been in an accident? also another thing the rear end probably needs bearings replaced if t makes a bad squeeking noise when goin over bumps. I reckon rear shocks top mounts might be ...

...bump the top of tv This is likely your convergence IC solder connections. Does it look bowed and rainbow colored? The red, green, and blue will be mis-aligned causing a shadow effect. If you can bump ...

...one of the little buttons on the front of the TV was stuck down. Don't know why, unless the maid bumped it hard as we never use them. Anyway, I poked/wiggled a few times at each button and the ...

will see it. It says manual/auto, switch it back to auto and the top should work. You probably just bumped it as my brother in law did, no convertible for over a year...good thing he lives in Seattle

GDI, V6 Royal N86W came with tyres 205/65/15. I am getting difficult driving the car in our african bumped roads. Which size can i replace with. 205 is the width in mm. 65 is the hight of the sidewall

My 2002 Mitsubishi Galant jerks when i am in first gear, especially when the ac is on. it bumps and jerks on average three to four times while accelerating in first gear. it does not **** as bad (or ...

bump/pothole etc it makes a nasty poppin thud noise. sounds like maybe a strut is loose or i dont know ne help? could be a number of things. check your joints and bushings under car and also with hood

Mitsubishi lancer 2007 equippe 1600cc When I go over speed bumps there's a noise coming from my front driver side of my car, even when I'm braking it's a noise coming from the same side! I

...top and 3" in on right side is a little darker? looks like the mirrors not lined up right Did you move or bump the TV? That can cause misalignment. Did anyone fool with the setup? Get the manual and ...

...top dead center of the number one cylinder. Even though the distributor rotor is pointing toward the number one plug wire terminal in the distributor cap, it could still be 180 degrees out of time ...