BULB AND LAMP I REPLACED THE BULB AND AFTER APPX 1 1/2 MOS I GOT A MESSGE TELLING ME TO REPLACE THE UV BULB & PLATE!!! WHY??? I can give you some possibilities. A loose connection, a broken or ...
clean the bulbs? Cleaning it is described in the product's documentation and in other Fixya solutions such as this one: http://www.fixya.com/support/t154553-ionic_pro_sizzles_crackles_when_turn As for
Question about Ignition Kit 2-8 HP Engines with Breaker Point Ignition #5012D
...clean everything behind the bulb before you put the new on in. You need a pick with a hook on the end-around the outside of the bulb is a ring that has to be removed--clean area and instal "new" bulb ...
...bulb and clean the connections when the bulb would fit some times they will need lifting back up, as bulb solder ends are different sizes due to solder ends. you can lift these up a bit, clean any ...
...bulb? If you can clean it and it comes off I would do it. This haze is caused by the extra heat the bulb was putting out before it blew. Make sure you blow/clean out all the dust you can. These TV's ...
...BULB REPLACEMENT. IT WILL SHOW AND TELL YOU HOW TO REPLACE HEAD LIGHT BULBS. YOU NEED TO WEAR CLEAN LATEX GLOVES WHEN CHANGING HALOGEN BULBS BECAUSE OILS FROM FINGERS AND HANDS WILL CAUSE THE HALOGEN ...
...bulb holder counterclockwise to remove bulbs.WARNING YOU NEED TO WEAR CLEAN GLOVE TO REPLACE HEADLIGHT BULBS BECAUSE THEY ARE HALOGEN BULBS. IF YOU TOUCH HALOGEN BULBS WITH BARE HANDS. OILS FROM SKIN ...
...bulb is a halegen so us gloves. There is the lens coming from the colour wheel did you clean it.Clean only with hot water and soft towel no chemicals.If you have used a chemical on it use soft towel ...
Question about 2003 Alero
...bulb cover lens is clean? Try swapping the headlamp bulb from one side to the other, if the problem follows the bulb, it has to be the bulb doesn't it. Don't touch bulb with bare fingers, use clean ...
Question about 2003 Alero
...the bulbs go in need cleaned. If you clean it just remove the whole holder just by squeezing the connector that hooks into the holder. This is a common issue. But more then likely it just the
Usually answered in minutes!
271 Questions
141 Questions
164 Questions
134 Questions