motor. Have a good torch with you. You will see the brush holders and the brush sticking out. With a small screw driver lift the brushes back up into the holder to see if you have any travel.? A front
...begins to fill. Today it wont fill or start, just sits there with red light on!!! it maybe your brushes are worn out, on alot of machines these days if the brushes wear the machine wont fill , or ...
Question about W 123 Front Load Washer
need to replace carbon brushes on Indesit Omega 1200 Machine will only spin when empty. Suggested brushes need replacing. Where are they located and what is involved in replacing. The brushes are ...
SPARKING FROM UNDERNEATH WASHING MACHINE, CHECKED BRUSHES IN MOTOR , THEY APPEAR TO BE OK. The brushes may look o/k , but you can still get excessive sparking from armature if there is a short on it ...
...without seeing the machine is - The motor has gone / failed. You could get someone to check the brushes on the motor, it's only a 30 minute job. If the brushes are ok i.e more then 10mm long, I ...
...it worked for two washed then drum stopped again I advise you to remove the motor, and check the brushes in the motor, and check for loose or broken wires at trhe same time. If brushes o/k, then
... although timer runs it's cycle there is no action from the machine! sounds like the motor or motor brushes worn,you 1st need to make sure its pumping ok. put it onto a spin make sure pumps ok,if no ...
I think the brushes are worn on my Indesit WIB101UK but searching for the correct brushes to replace worn ones is proving difficult!! Please could you advise me of the correct ones I would need. The ...
Question about Door Handle Kit for W123, W133, W143, W161, W83, W93 Washing Machines
...brush in a brass sleeve, I bent the lugs on the sleeves up to advance the brushes slightly towards the commutator and reassembled the motor. Machine started on next try. The ...
Question about Door Handle Kit for W123, W133, W143, W161, W83, W93 Washing Machines
my service washing machine is sparking underneath what could it be Loose wire or motor brushes may be on their way out or motor going faulty.Check the easiest and cheapest first as a new motor can be ...
Usually answered in minutes!
893 Questions
100 Questions
91 Questions
15 Questions