...brush-head assembly unit by unscrewing the 4 screw screws that hold in down in either corner; then find the side of the unit that has the gearing inputs, and unscrew all the screws until you get ...
could be an issue with the gears being stripped in the brush motor assembly or inside the brush compartment holder. If the gears are fine the brush motor itself may be blown. A new one is about $30.00
...brush assembly. ? The original date and location that the Roomba was purchased Title: Where can I find the serial number/product code for my robot? URL: ...
...brush drive assembly. If its under warranty replace the assembly. If the warranty has expired and you have the skill, you can remove the assembly and vacuum it aroundthe motor. Next remove the screws ...
...brush assembly and see if any of these things are rapped around those ends. Cleaned that off and put a little WD-40 in there and that should get you going. Mine did the same thing and no mater how ...
...brush and screw back in. Let it dry for at least overnight just to be sure. And that's it! If you're not very hands-on it might be better to let somebody else do it for you, you don't want to get the ...
...brush assembly is closed, it wedges rather tightly next to that yellow spacer on the left. This causes a lot of friction and heat, and mine's worn away quite a bit already. My solution was to just ...
...Head Assembly and the other end that connects to the brush motor may also suffer From the same condition. Here are some of my photos to reference ...
...brush assembly yellow? If so, it pulls off. I'm going to take a flier and guess that you didn't know that, and your bearing is jammed up with hair. This is what the bearings look like: Make sure they ...
Usually answered in minutes!
191 Questions
140 Questions
90 Questions
79 Questions
30 Questions