...Assembly is worn out the brush roller can not spin. So now it looks like I need to buy a whole new brush roller,unless I can find a place that sells the Bearing Assembly for part number 61445-1,which ...
...brush assembly out, popped the middle brush back in & it seemed secure. Once I attached the brush assembly back into the machine the middle brush fell out again & will not stay put. I've only had the ...
Question about SteamVac F5914-900 SpinScrub Upright Vacuum
...brush assembly if I knew that was the problem. One of the latches snaped off some time(?) and the brushes are wearing down. The brush assembly does fit back into place and every thing else seems to ...
Question about F5906-900 Upright Steam Vacuum
...brush assembly out by holding the two tabs, and all seems clean and the brush assembly rotates easly... onced the brush assembly is removed. What I did notice is the female driver slot (found in the ...
Question about SteamVac Carpet/Upholstery Deep Cleaner Vacuum
...assembly. Clean the lint screen first, then try to turn the brushes by hand. If they will not turn by hand remove the brush assembly, if the brush assembly turns freely the turbine may be
Question about F7425-900 SteamVac V2 Widepath Upright Vacuum
...brush assembly is broken. If the whole brush assembly keeps falling out, the drive pin shaft may be damaged. To order a replacement brush-block follow the link below. Search Results Hope this
Question about SteamVac F5914-900 SpinScrub Upright Vacuum
...brush block assembly That is impossible, unless the brush enclosure is broken. The brushes are enclosed in a cartridge (Brush Bock). You must replace ...
Question about C3820 Commercial Steam Vac Black and Gray
...brush block assembly is broken and will need to be replaced. Follow the link below to place an order for a replacement brush block. Search Results Hope this was helpful! Same thing happened to me and ...
brush assembly & then reseat the brush assembly. Before doing so you should remove both Tanks from your Hoover. Then there are two buttons on top of the Nozzle Assembly that holds the brushes. You
Question about SteamVac F5914-900 SpinScrub Upright Vacuum
...to rremove the brush roll Just pull the brush assembly straight out slightly and look for 4 release tabs....squeeze the tabs and pull the assembly out. Make sure cord is not plugged in. ...
Usually answered in minutes!
746 Questions
388 Questions
262 Questions
179 Questions