bridged mode your amp will become monaural (single channel, double power). If you still wish to bridge it: Switch of power. Set mode switch behind amp to "bridge" position. Connect speaker positive to
...bridged mode? setup of bridge mono mode:-1-turn your amplifier off.2-connect input wiring to channel(1) input--3-connect speaker across positive outputs terminals-do not use negative terminal when ...
...bridged channel, but worksfine in stereo. they all have equal volume and no static or intermitten problems, non of the fans are coming on but i assumed its cause the cover is off and its pretty cold ...
Question about CE1000 2-Channel Amplifier
CROWN CE1000- slips into fault immediately after connection CROWN CE1000- powers up fine, goes through fault protection testing fine, but unit clips and slips into fault protection (cycling) ...
I am trying to bridge two macrotechs 1200 and I am getting a loud huming noise . No sound. Just that noise. When I run them in stereo mode they work perfectly fine. What causes that? Let's review ...
Question about CE2000 2-Channel Amplifier
what should i set the micro switch on the back at? 1.4v or 26db, what determines this setting? Power:2 ohm stereo (per channel): 975W4 ohm stereo (per channel): 660W8 ohm stereo (per channel): 400W4 ...
distorted audio The audio level is suddenly very low and distorted, no changes in connections or use. Check the connections to the speaker(s) and make sure the connections are clean and sound first. ...
Usually answered in minutes!
62 Questions
68 Questions
33 Questions
21 Questions