Questions & Answers for: Pioneer bridge wires

...for my XA4150: 2 ohm output: 100 watts x 4 RMS at 0.1% THD; peak 2 ohm output is 200 watts x 4 Bridged output: At 4 ohms. the output is 200 watts x 2 RMS at 0.1% THD; peak bridged output is 400 ...

...wires, both negatives go to the bridge negative terminal, and both positives go to the positive bridge terminal. Series-parallel: A combination of the two. say two speakers in series, and one hooked ...

...your Subs in Series. This way the current that passes through one has to pass through the other. Bridge your amp. and follow the wiring below. Amp+ to Sub1+Sub1- to Sub2+Sub2- to

...want to wire 2 infinity reference series subs to my alpine mrv 1000 amp. i want to connect them to bridge them to get them to hit much harder. but when i do this the amp shuts off and over heats? i ...

...AMP AND ONE TS302R 12" SUB HOW DO I WIRE THE ONE WERE IT WON'T FRY THE AMP IS A 760W AMP 380 BRIDGED X 1, 125 X 2 AT 4 OMHS, 190W X 2 AT 2 OHMS. MY SUB IS 800 WAT PEAK, 150W NOMINAL, 4 OMHMS ...

I have a Pioneer GM-5300T amp wired to a 10 inch kicker sub. The music plays throughout the speakers of my car but the sub goes in and out. I noticed that the amp's power light dims when the sub goes ...

amps on woofers are fine just won't hit i installed my 2 12" dvc 2ohm woofers and i have a 1400 watt amp to get to 2 ohm i wired my woofers in series/parralell. the amp is bridged but no sound will ...

...this sub is a dual coil 2 ohm. so to get best bang for your buck you'll want a 2 channel amp and bridge it. Your sub is 400 watts RMS, So you'll want an amp that has the same rating. I'd recommend ...

...full range speakers with 50w at 4 ohms Nd one subwoofer with 70w at 1/2 ohm. How do I wire the subwoofer? Do I bridge the two rear speaker wires or just choose one? no you need to bridge two ...

...can be added and if that bridge is missing, the tuner signals are sent on to the internal amplifier. On one of mine, that bridge was a 2 wires bent to fit into RCA jacks on the rear of the