Questions & Answers for: bridge wires

Ad

Question about Broadband Networking MN-100 Wired Base Station (M51-00001) Router

1 Answer

...Networking 10 100 Ethernet Notebook Adapter MN120 To resolve this issue, remove the network bridge. To do so, follow these steps: 1. Click Start, and then click My Network Places. 2. In the ...

Ad

Question about GM-X962 Car Audio Amplifier

2 Answers

...want to wire 2 infinity reference series subs to my alpine mrv 1000 amp. i want to connect them to bridge them to get them to hit much harder. but when i do this the amp shuts off and over heats? i ...

Ad

...bridge. Then there should be just 2 wires a plus and a minus to the amp. Then follow the amp bridge wiring which should be found right above the speaker terminals it will be left plus to right minus ...

Question about Programmable Thermostat Heater

1 Answer

...wires going to the new thermostat. On the old thermostat, we have a red wire at RC terminal with bridge going to R. Q: Where do we put red wire on the new thermostat into R terminal or RC terminal ...

Question about Programmable Thermostat Heater

1 Answer

...out how i should wire my Kicker S12L5 sub to my Kicker Zr360 amp. should i wire it for 1ohm and bridge it or what if you could help it would be much appreciated thanks. Nick What is the wattage

Question about Programmable Thermostat Heater

1 Answer

...the amp when hooked up using both channels. the subs are wired in series and wondering if i should bridge the amp? but what terminals would i then use to do that? also would it be running at proper ...

Hi, I want to know what is the best way to wire these subs. (Pair). I have heard of several ways. I have a 4 channel amp the soundstream picasso 4.760. Bridged it produces the most power. I was told ...

how do I wire up my 4subs in bridged to my peace 2600 I got 4peavy subs to so what is the best way to wire them up in bridged Hi, Please state the subs impedance, but assuming 4 subs with 8Ohm Voice ...

Question about Pv 2600 Power Amplifier

1 Answer

Need wiring diagram for Lionel 313 Bascule Bridge There are 5 terminals on the bridge number them from outside to inside 1,2,3,4,5 Terminal 1 gets connected to the outside rails on a V,Z,VW,orZW ...

Question about Pv 2600 Power Amplifier

1 Answer

...bridge mode; You are driving the speakers at a volume exceeding the maximum power output of the amplifier; The gauge of the wires you are using to connect the amplifier to the speakers is too small; ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Computers & Internet Experts

k24674

Level 3 Expert

8092 Answers

Brad Brown

Level 3 Expert

18689 Answers

Cindy Wells

Level 3 Expert

6281 Answers

Are you a Computers & Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...