Questions & Answers for: can you bridge on speaker

bridge" position. Connect speaker positive to CH1+ve terminal of amp output and connect speaker negative to CH2 +ve terminal. Be aware that now, in bridged mode your amps output power delivery is 1100

...bridge that your speaker load DOUBLES to EACH channel. In other words, what your amp saw as a 4 ohm speaker going to one channel alone, it now sees as a 2 ohm speaker on each channel when bridged. Be ...

speaker out put runs + - - + and will bridge the left (+) with the right (-) but when we bridge with the left (-) to the right (+) the second sub recieves no power while the first still does, and when

...bridge each amp and run one speaker per amp on a bridged channel. One behringer amp bridged to one 4 ohm 2000 watt program speaker. just be careful not to over power the speaker because you will have ...

...speaker as bridge , take a closer look, there must be a _ sign and + sign at the positive output for channel A and B, it is usually labeled bridge.read manual for impedance loading, other amps cannot ...

...two speakers. trying to see if i can bridge it and use a singe speaker? left positive and right negative-make sure the speaker that you intend to run in bridged mode is 4 ohms or you will kill your ...

bridge the vega 124 or just use 1 channel on a punch 400x4 Here are the important concerns: The power rating of the speaker(400W) should be 25% HIGHER than the maximum output of the amplifier BRIDGED.

speaker output 4. Now the amplifier is in bridge mode, which will give you 300 WATT RMS at 4 OHM load. If you are bridging the amplifier to run sub woofers then do not forget to set the X- Over to LPF

...wire off amp bridged im useing 2 woofers in my systems and want 2ohm stable do i use both speaker outs or bridge it and use one speaker out Just use both speaker outputs, no need to bridge

...bridge output to + of one speaker, - of that speaker connected to the + of the other speaker, and = of that speaker connected to - of the bridge output); Turn the amplifier output down (but this is ...