Question about 500-Watt Monoblock Amplifier (BA1500) Car Audio Amplifier
jackhammer. The amp is 2 ohm and the speaker is 4 ohm. Can I bridge by using 1 channel? you can only bridge it if your amp is made for it......the only other way is to have another of the same amp....
Question about 500-Watt Monoblock Amplifier (BA1500) Car Audio Amplifier
...jackhammer. The amp is 2 ohm and the speaker is 4 ohm. Can I bridge by using 1 channel? A 2 ohm stable amp should be able to be bridged to 1 ohm (consult owner's manual for bridgability), but a 4 ohm ...
Question about ELA500.1 Car Audio Amplifier
...jackhammer. The amp is 2 ohm and the speaker is 4 ohm. Can I bridge by using 1 channel? when bridgeing an amplifier it always sees half of whatever load you have on it, so if you have a 4ohm speaker ...
Question about JackHammer JH202 Car Audio Amplifier
jh202 amp works for a few minutes stops for a few minutes any ideas Sounds like the amp is going into Protection Mode. Does yours have green LED light then RED LED on it? The green is power and the ...
Question about JackHammer JH202 Car Audio Amplifier
...subs would be to bridge channels 1 and 2 and wire one sub to it. Likewise, bridge channels 3 and 4 and connect the other sub. If you connect both subs in parallel, the impedance will be too low ...
...by you trying to run a 2OHM load on an amplifier which is designed to run only on 4OHM when it is bridged, the amplifier is most definatley cooked. An authorized MTX technician should take a look
when i plug the remote wire in with the ground and power wire plugged in tight, i'll wiggle the remote wire and the heat and power safe lights flash on, but if i just leave the remote wire in the ...
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions