...break wire. Is it necessary to connect the parking break wire for the unit to power up? It's not powering up, even after resetting the unit. Try grounding the parking brake wire instead of attaching ...
break wire should be connected to so I can bodge one in (or buy a correct harness) Thanks your car probably wont have one this wire is designed to be hooked to the park brake switch wire so you cannot
Question about 2002 Alero
...break light wire and the running light wire on the back left side. Would this make a diffrerence. Should I run a wire across and connect them to the other side as well? i would use a multimeter to ...
break lamp switch light stays on , on the dash. i still dont have my breaks. i think my wiring problem. Try checking the light assembly itself. Sometimes water get in and will corrode the wiring close
...Break Light is Dim When Breaks are applied Driver side. you may have a bad ground where the ground wire attaches to the body. its a black wire and the connector is just below the trunk latch on the ...
...break light switch was blown. they said that it should be fine now. i hooked up my trailer again and noticed a short time after that the breaks were not lighting uop again. brought it back again and ...
...wire it with a spool of corona wire how eber i would check from trhe people you are buying the unit from if there are any modifications for the unit i have not seen any break the wire breaks thats ...
...feed. If it does then the break pressure switch is faulty or the wires to it are broken. Use a lamp as a test lamp. Connect flex to the bulb and you can follow the wire to the break. Hope that
Question about 2002 S-10
wire do I hook up for break light switch under dash THE BREAK SWITCH IS MOUNTED ON A BRACKET AT THE CENTER OF THE BREAK PEDAL,JUST FOLLOW THE CENTER OF THE PEDAL AND YOU WILL SEE WHERE THE PEDAL MAKES
Usually answered in minutes!