Questions & Answers for: break light switch operation 1998

break peddel next to steering colume under dash. brake light switch is located behind the brake pedal if this dosent work theres a safty switch i believe in the sterring colum that releases a rod that

...break from the use of tilt wheel. Again the use of a test light will determine this you'll actually have to remove the lower panel to the steering column and figure out which wire goes to where. I ...

...break light. Turn signals work fine. Checked fuses - fine, checked bulbs - fine. What is the problem with the break lights? Check the brake light switch should be a orange wire with 12v then a white ...

break lights stay on so i replaced petal switch and the two tail lights still stay on but the third break light is operable itg maybe this simple cause l've seen stranger, try replacing both bulbs,

...switch is not the problem first off, be sure your low beams aren't both burned out. it happens all the time. next check your dimmer switch operation. (i'm betting on low beams burned out) good

break light on my 1998 gmc suburban does not work i allready check the break padel switch and bulb they are good Does the third brake light work? If it does the get a test light and check the circuit ...

...Start only with light on!! Not when off!! When mess with starter switch !! I would replace the ignition starter switch, that will likely cure the problem. This is the multi wire switch the key ...

break light switch in 2008 gmc sierra 1500 k i replaced break light switch and now break lights stay on but dont work properly You have not set the switch correctly, at rest the switch is operated and

I have a 1998 GMC Jimmy The parking lights and my break lights all come on but the Headlights and the high beams do not come on. check all your fuses, if they are good check you light switch

Break light switch for 1998 safari We're do I find the switch Above the brake pedal arm