Questions & Answers for: kawasaki brake cleaner

Question about 2005 ER-5

1 Answer

brake dust and dirt. Apply a wheel cleaner first and let it settle before scrubbing it off. Chrome wheels will require specific cleaners, so be aware of your wheel's finish before purchasing a cleaner

Ad

...Brake Cleaner. (This can be a fiddly job, don't loose any screws!) These are a few things that, in my experience, are the simplest way of self problem solving before you take the bike to a mechanic. ...

Ad

Question about 2006 ZX-6R

1 Answer

...modifier which will coat the clutch plates and cause them to slip and then glaze. the clutch plates will have to be removed and cleaned with brake cleaner and lighty sanded to remove the glaze. ...

...cleaner I can use on the rotor without taking the pads off? No I'm afraid you will have to remove the pads, clean them & thinly smear the back & edges with caliper grease You may also wish to ...

...cleaner in the carbs while it is running the one on the far right the front brake side the engine does not rev up the other 3 it does, the bike sat for 3 years but I changed the oil and put fresh gas ...

Question about 2000 ZZR 600

1 Answer

...brake cleaner sort this problem HI, THE TROUBLE WITH BRAKES ON THE OLDER BIKES IS COMMON, AND NOT UNUSUAL FOR THIS TO HAPPEN ON A YEARLY BASIS, MY THOUGHTS ON THIS ARE THE BRAKE CLEANER WILL ONLY ...

...available. If it is just sticky, you can free it by repeatedly applying the rear brake as hard as you can, after spraying with a brake cleaning fluid. Leave the cleaner to work for an hour or

Question about 2000 ZZR 600

1 Answer

...sticking. Happens over time. what you need to do is disassemble, inspect and clean the plates. If the parts are in good repair, this resolves the sticking issue. I use carb cleaner or brake

...module is simple and can be replaced with only a 24 volt relay without the kick start feature or Brake. If you want the brake then you can use two 24 volt relays still no Kick Start. For those of ...

Question about 1998 VN 800 Vulcan Classic

1 Answer

...brake cleaner spray and then spray wd-40 on it. Move the kickstand up and down to further lubricate it. The switch will now smoothly move in and out instead of being stuck in one position. I bet that ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Bob G

Level 2 Expert

104 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...