Questions & Answers for: bowflex motor board for treadmill

...these problems are in relation with motor itself, I mean, internal bearings, short circuit. So if your treadmill stops is bacause the circuit board detetecs an over current fron motor. I hope help ...

...Bowflex TC1000 that will not start. The console powers up, the red light on the power switch lights up and the green led and red led on the controler board are lit. A/C voltage to board is 120 volts. ...

runs at high speed only has no display and no control Your motor control board sound defective, there is likely some debris or liquid that has shorted out the contacts. Contact Bowflex for replacement

bowflex treadmill 5 series in toronto getting L5 error will not start. sometimes it works and than stops. There are four typical causes for this problem : 1) The walking belt and/or deck are worn. (85

bowflex treadclimber just stopped working. The control board workers bu the belt will not move. I bought the treadclimber used a year ago and have used it alot. But i have been sick for a month and it

bowflex will not pass calabration still and the treadles go up and down still wont pass also silcone lubbed the treadles what can I do I feel like I have a 4000.00 paperweight after 3yrs HELP PLEASE ?

39;t move, the board works Motor may be disconnected or defective. Contact Bowflex for troubleshooting assistance, or they can provide an electronic copy of a service manual with troubleshooting steps

Bowflex series 7 treadmill Calibration fail. Next indicated action? Once powered up, the motor runs for a second or two and stops. Cannot turn the power switch off, must turn off at main bottom power ...

...motor control board lit? Is the yellow RLC lamp on the motor control board lit? 1. Unplug the treadmill from its 2. Wl alk on the belt manually. (push belt) 3. Does the yellow MOTOR lamp light while ...