Questions & Answers for: bottom bracket Freezers

...hangs on the wall with three screws. two at the top and one at the bottom. Just loosen these screws and the ice maker will lift off the bracket and you can then reach the wiring harness to unplug

...bottom of the door and the floor to hold it in case it slips. Remove the bracket holding the pin and hinge assembly taking note of order of removal of parts. Slide new cams on. You probably need

bottom , circulating fan is not working. Hi Guys, I tested fan removed(to 240vlts) neg- pos to wires+earth to mount bracket, and found to be working, reinstalled and found power - active to both wires

Have a 13 yr old TPX24pr. 1-2 inches of ice formed on bottom of freezer and behind support brackets for shelves. Where to start? Did you find out what was wrong? Mine is doing the same

...bracket,undo bolts and transfer to opposite side leaving loose,slide door down ,then on top of door transfer plug to opposite side(if needed)slide door back up and refit bottom hinges/tighten bolts. ...

...BOTTOM OF THE DOOR TO COMPENSATE THE GAP. THANKS Frank Ford. Good day, Just go to your local appliance parts house. They will have the shims you will need. Remove the top bracket, open the door ...

...there should be three screws on the hinge bracket that connects to the top of the freezer.  take out those screws and remove the bracket.  the door will then lift off the bottom

bracket at the bottom had a coil appear where it didn't have one before so we removed that. What have we done? It sounds like the door got shut when something in the jam and you may need to loosen the

My Frigidaire upright freezer has a big gap on the bottom left corner and the top left corner is hitting the freezer body! I put a new door seal and new feet peg brackets and new screw in feet pegs ...