Questions & Answers for: Intel what is boot block

...boot block compatible version ver .003,bad bios checksum.starting bios recovery".now the monitor didn't turn on. please help Try to go to safe mode choose system restore. If you cant get through it. ...

computer hangs after 5 minutes from boot my ecs p4vmm2 has an intel processor 1.7 ghz. It hangs after 5 minutes from boot, whether on safe mode, dos mode, or even on reformatting mode. could this be ...

block of 3 pins that control your BIOS on the motherboard. See page 53 of the manual. Here is a link if you do not have the manual. Intel DG31PR manual Make sure the jumper is on pins 1 and 2 when you

my motherboard are defective beforing booting no display usually block out what do you think... hello there, are you sure it was mother board,have you tried to swicth on your computer without ...

diskette disc 0 error while attempting to load windows Do you have it set in bios to boot to cd? Check all your drive cables including power and make sure you have not pushed any of the connectors on ...

wrong display on boot up. A while ago I had changed the display on on the system and was using a pci graphics card now when going to the on board graphics for a reinstall of windows the monitor ...

...boot block recovery mode has been set, set switch bootblock recovery to the open/up position before rebooting.'' go into the bois and set the password off, restat the pc press delete or f2 yust read ...

...boot block recovery problem hello my computer was working properly but when i started it few days ago it shows "password have been cleared. place back the clear password switch to its original ...

... from which you will be able to remove your system password. Hope it helped, Franz When your system boots up, you will see a message on one of the very first screens prompting you to press a certain ...

...the heatsink fins. I have cleaned it all up and the heatsink should be fine now, but when I try and boot I get a message saying it previously shut down due to a thermal event and to press F4 to enter ...