...are 4 nuts for each hub. I'll be using new nuts for the reassembly. Those are not nuts, they are bolts. The torque spec for those bolts is ...
...bolt from the torque axis (front) engine mount. Lift the engine with the support fixture until the power steering reservoir touches the strut tower cross brace. Loosen the bottom two bolts on the ...
...50 degrees cylinder head torque step 1 35 ft lbs. step 2 an additional 130 degrees step 3. 4 center bolts an additional 30 ...
...bolt torques spec 1999 Buick Le Sabre 3.8L head bolt torques spec 3.8L V6 cylinder head bolt torque step 1 37 ft lbs. step 2 an additional 130 degrees step 3 4 center bolts an additional 30 ...
Torque axis mount. Tighten bolt to 87 Nm (65 lbs. ft.) Coolant pump pulley. Tighten bolts to 15 Nm (11 lbs. ft) . Coolant hoses onto the pump. install drive belt . Fill the coolant system. Connect the
...bolt from the torque axis (front) engine mount. Lift the engine with the support fixture until the power steering reservoir touches the strut tower cross brace. Loosen the bottom two bolts on the ...
...initial installation.New head bolts must be used when cylinder head isreplaced or re-installed to obtain proper torque. always torque from center Tighten each bolt an additional 90° in
...torque speck really on an axle bolt. Just snug it by hand real good and make sure to stick a new cotter pin in through the axle and axle bolt to prevent the bolt from self un-threading. That all I ...
...head torque 3.8l i need to find out what the cyclinder head torque is on a 3.8 First off, these bolts are designed to stretch when they are installed; so do not reuse the original bolts; always ...
...to model category. For the lower intake: Step 1 - Tighten down to 62in/lbs (not ft/lbs) Center bolts first then outer bolts - Bring all bolts to finger tight then tighten in 1/4 turn increments ...
Usually answered in minutes!
1,731 Questions
1,603 Questions
1,084 Questions
904 Questions
897 Questions
