Questions & Answers for: BMW bolt torque

...Torque greased axle bolt to 50NM, then compress forks several times without using brakes, then tighten both LHS axle pinch bolts to 8NM, then tighten both RHS axle pinch bolts to 8NM. Then test your ...

I just need the torque specs the right side engine cover bolts on my '87 K75s k75s right hand engine cover bolts torque to 8+/ - 1 Nm 6+ /- 0.5 lbf ft no tighter than this please they brake off?

how many degrees do i tight tha bolt for head angen The head are torqued down in 3 steps (1) tighten to 30nm or 22 ft lbs. (2) torque angle 90 degs. (3) torque angle 90 degs.

I need to know he torque spects for the oil filter container the bolts on to the moter on a 94 BMW 318i...there are 6 bolts...I also need to know the torque spects on the alternator mounting bracket..

the time, they put their torque wrench on and don't get any more turn on the bolt before the wrench clicks. That means the nut is already tighter than 85 ft-lbs, and they have no idea how much tighter

...set and a (BMW)screwdriver.- remove cabin filter(3 cover knobs) and cabin filter housing(4-T30 bolts or screws).- remove four bolts and cover of the engine. not to forgot to cover oil fill after ...

...bolt torque sequence on a 1998 BMW Z3 Roadster 2.8 liter? Its usually from the center out in the next most opposite bolt (star) sequence. ie. if its a 14 bolt head 1-7 top, 8-14 both from front it ...

...working across the face of the plate until all bolts are tight so as not to warp the case of the pressure plate torque specs may be found on the net ( google --type in pressure plate bolt

on a bmw e36 318i m42 engine? Over torqued and you run the risk of a stripped thread or broken head bolt. Under torqued and the compression gas will leak past the head gasket and burn it out

...Head bolt torque Oct 16, 2013 DIY: Yet another Torque Guide (YATG) May 20, 2020 HELP - Flywheel Install Torque Spec Jun 26, 2010 Flywheel Torque Specs May 20, 2017 More results from ...