Questions & Answers for: Flotec body nut

...remove the motor from a Flotec FPS5172, 1-1/2 HP. Have a Flotec FPS5172 1-1/2 HP. Removed the pump body and diffuser, then removed the 4 nuts holding the motor, but still can't remove the impeller, ...

Cracked pump body on a Flotec FP-4012-10 pump (froze). What can I use to fix it - fiber glass, etc? Thanks sand the crack area well and use JB Weld

pressure switch Remove cap from pressure switch (small nut on top). You will see 3 threaded studs with springs held down by nuts at the end opposite from wired connections. Avoid wired connections ...

I have a 3/4 hp shallow well pump. It running at about ten on my pressure gauge. That means no pressure. What can I do? If the pump turns on and off real fast, then your pressure tank is water logged.

I had a water line bust. After fixing the leak, I lost water pressure. Someone tried to fix the problem and now we have little to no water flow. I have to pumps . The smaller pump that feeds the house

...you have a two part plug, then separate them and plug the cord in that leads directly to the pump body. This will tell you if the pump is working. If it is then replace the float switch assembly. ...

body. Could I use some type of epoxy to seal the crack? Thank you for posting your question here on Fixya.com. Once you remove the nut use a flat tip screwdriver to release the wedged-on band from the

Pressure switch, TC2151, on my shallow well system (used for lawn irrigation) needs recalibrating. It shuts off at 60 PSI - I think I can live with that although I would prefer about 55 PSI. I saw ...

...you want to test the pump, separate the two plugs and plug in the one that leads to the main pump

pump body and bracket position bolt mount repair. Hi, I was installing new 4032-10 pump. I wanted to put the pump on a wooden base, so I removed the two bottom bolts so I could mark position on the ...