Questions & Answers for: Cadillac body nut

Can not find the body control module on my 1989 cadillac sedan deville -- anyone know where it is? you need to take glove box out. It's right behind three three 7mm bolts for the plastic piece that ...

body It is in front of the drivers side rear wheel. To get to it, you must get the car up, (on a ramp or something), it is connected by a hose (with a clamp) and a nut. There also is a bracket to hold

...body to the intake manifold. Completely remove the intake manifold and have clear access to the starter motor. Remove the 10mm nut on the starter for the solenoid wire, remove the 13mm nut on the ...

...body of compressor behind the pulley - freon hoses need to be unbolted -freon if it still as any needs to be recovered - r12 - the clutch is in place with snap -ring on front of compressor shaft - ...

...Disconnect programmer electrical and vacuum connector, then remove programmer. Disconnect body control module electrical connector, then remove module attaching screws and module. Remove ...

...body out of the engine compartment. Unbolt the solenoid 'S' terminal nut and battery cable nut. Remove the starter motor mounting bolts, and lift the starter motor out of the manifold cavity. To ...

...body ducts. Raise the vehicle. Install the passenger side engine mount nuts. Tighten the upper nut to 30 ft. lbs. (40 Nm). Tighten the lower nut to 41 ft. lbs. (55 Nm). Install the passenger side ...

locate pcv valve.pulled throtle body nothing or valve covers pcv valve.not in valve covers not behind throttle body. Crankcase ventilation system is used to consume crankcase vapors created during the

...light Open the liftgate. Remove the liftgate applique. Refer to Liftgate Applique Replacement in Body Rear End. Remove the back up lamp socket (1) from the liftgate applique by turning the socket ...

...3"x2"x2", with a plunger sticking out of it that pushes on the throttle linkage at the throttle body. If you're skilled in repairing small devices, sometimes the actuator can be disassembled, ...