Bobbin holder problem. Needle hits bobbin holder and doesn't grab the bobbin thread. It will break the needles if persisted. Is the needle all the way up in the holder? Have you checked the timing ...
bobbin holder while trying to remove the bobbin holder ,I made the mistake of moving the two side pieces and the whole bobbin holder fell out.I tried to put it back in but its fighting me. can you ...
...bobbin holder is inside. Loosen the hand guide to stop the needle from going up and down. Pull the thread around the top thread guide and back into the bobbin holder. Thread the bobbin and move the ...
Question about XL-2230 Mechanical Sewing Machine
bobbin holder turns so the needle hits the holder and breaks. While cleaning the dust and lint out, I opened the case and removed the bobbin holder. I suspect there is some spring now missing to align
Question about XL-2230 Mechanical Sewing Machine
bobbin holder , moves the bobbin holder out of place , james , have taken it out cleaned everthing under the bobbin and takewn the underneath cover it will work for a bit sometimes , but then suddenly
Question about XL-2230 Mechanical Sewing Machine
...bobbin holder and thread the feed thread over the top from the spool or thread. making sure that you run it through the auto tensioner. Set the auto thread tension to +1 to start, go ahead and thread ...
Question about XL-2230 Mechanical Sewing Machine
...bobbin holder is stacked Hi! I made a mistake and started sewing without bringing up the bobbin thread. A few seconds later the machine stopped and the hand wheel didn't turn any more. I took out ...
...bobbin holder removed bobbin holder to clean, when I replaced it the needle hits the holder. Is holder supposed to turn? Hi, sounds to me like you haven't refitted the bobbin correctly Regards ...
Question about CS6000i Computerized Sewing Machine
...bobbin holder in there correctly to get the machine to sew properly. I HAVE TRIED OVER AND OVER IN DIFFERENT WAYS TO GET THE BOBBIN HOLDER IN THE MACHINE PROPERLY While I know it can only go in 1 of ...
...bobbin holder I have a Janome 625e Sewist that has until now been working well. I tried a foot from another machine because I don't have a rolled-hem foot, and this has caused problems. I have now ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions