Question about AV-56WP30 56" Rear Projection Television
...usually requires a repair tech I had the same problem that required a $400 technician fix. 1st time i tracked it to a $0.05 resistor blown. could not find in radio shack... was due to bad
Question about AV-48WP30 48" Rear Projection Television
blown RK46 half watt resistor (faded colors) in the convergence pannel. I cannot read the coded colors. If anyone help me to send the value of it or email the schematic will help me alot. Thanks Sam 2
.... any solution? If you replaced both ICs you may have a blown resistors usually the 1.8 ohm 1 watt resistor or the other ones next to it will be blown if you still cant do alignment after repalcing ...
...blown fuse, 3 bad transistors and a burned resistor in the power supply section on the main board. I replaced these transistors (with NTE transistors). I couldn't find the exact resistor value I ...
...resistor that was blown. I replaced both STKs and the resistor and see absolutely no difference. I went to set up and did the auto convergence and the bottom line, the TV is just as it before I tried ...
Question about AV-48WP74 48" Rear Projection HDTV-Ready Television
...resistor that was blown. I replaced both STKs and the resistor and see absolutely no difference. I went to set up and did the auto convergence and the bottom line, the TV is just as it before I tried ...
Question about AV-56WP74 56" Rear Projection HDTV-Ready Television
...tried helped at all. Need to replace both convergence amps and any related resistors that may have blown
Question about AV-48WP30 48" Rear Projection Television
...blown resistor. I've ordered replacement resistor, but I just wanted to see if there is a reason why this resistor would blow, and if it will blow again after replacement? Hopefully it takes care of ...
...power surge/outage & JVC won't stay on. Clicks on and starts to cycle, then shuts down. Fuse blown? Reset button somewhere? or trashed? If appears "OVERLOAD" before turn off, you ned change a ...
...of thing that are wrong. 1 shorted diodes/ 2 shorted output transistor/ 3 shorted resistors /4 blown or swelled capacitors get an engineer to check it out good luck regards ...
Usually answered in minutes!
443 Questions
354 Questions
208 Questions
175 Questions
149 Questions