blinking red power light i have a blinking red power light on my receiver. I have already tried to unplug and cool down the unit but when it powers up I get the green light for a few seconds and then ...
blinking red. I cannot get the readout to change by pushing any buttons? Seems almost to be frozen. What is "PROTECT" mode and how to I get out of it to start using the reciever again? replace all the
...light blinks off and on Red This unit Denon 1505/485 quit playing while it was being played very loud. I have the schematics for this unit but not the operators manual, * The speaker terminals are ...
...red light blinks the whole time. What can be wrong? Please help? Could be several things. First, disconnect all speakers and try the RESET suggested above. Could be a shorted speaker cable. If not, ...
Question about AVR-1905 Receiver
...blinking red light after 5 seconds when I power the receiver on it goes to standby with a fast blinking red light after round 5 seconds. I've tried unplugging everything, powering off, and removing ...
...week. Everytime I put the unit on Zone 2, the until shuts off and the red light begins to blink. I have not made any modifications to the system. What could be the problem? Check for shorts in Zone
...blinking red light and shuts off...Any clues? This is a protection mode. The receiver protection circuit detects an internal problem like missing power supply voltage or blown channel and ...
...red light is blinking on my denon avr 1508 I am using a Denon AVR 1508 . I have connected 5 speakers +1 sub woofer . But it is not working . A red light is blinking on the amplifier. After that the ...
Question about 5.1 Channel Receiver 1080p AVR-1513
...blinking red light Sounds like you could have a bad speaker connection. Try disconnecting the speakers and see if it stays on. If so, connect one at at a time until it goes off to determine which
Question about 5.1 Channel Receiver 1080p AVR-1513
...blinking red. when restarting it scans itself and then it switches off again The receiver is going into protect. Could be a number of reasons for it. Shorted amp, bad voltage regulators, etc. Would ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions