Questions & Answers for: bleed slave cylinder lines 91

...bleed in 2 points. One is the slave cylinder, the other one is in the joint of the line (hydraulic line) when it passes from the chassis to the engine (right above the transmission). loosen the bolt ...

...all bolts around trans bell housing, pull trans away from engine, slave cylinder slide on input shaft of trans, remove slave 10mm bolt's and replace slave. after all reassemble bleed clutch ...

91 mercury capri will not idle i just changed the timing belt and a fuel pump in my 91 merury capri and now it will not idle. what can cause this ? Clean the idle speed control valve and the throttle ...

...slave cylinder so that i can bleed the clutch lines, please help I had a 92 Chevy Cavalier which had the hydraulic clutch system like yours. I had intended to flush and purge the hydraulic clutch ...

my 93 mercury capri has a clutch fluid leak. where do i put the break fliud in? i cant find the res Why not just replace the clutch slave cylinder? A 12.00 part.

slave cylinder components-1988-95 models Click to Enlarge Cover all hydraulic lines to prevent dirt and moisture from entering the system. Remove the bolts securing the cylinder and remove it from the

...slave cylinder, perform bleeding of system to rectify. Always perform repairs for both sides even though only one side is leaking now. It would fail sooner or later if not repaired now. didnt specify ...

...bleed screw on the slave cylinder. ... Attach the hose to the bleed screw. ... Open the bleed screw on the slave cylinder. ... Have a friend press the clutch pedal in and hold it. ... Close the bleed ...

How do i change slave cylinder on 91 mercury capri I would love to help you with this but I'm not really good at it, sorry.

...cylinder. The cars I had, the hose is hooked up above the bottom of the reservoir because if you have a leak in clutch you do not want to run out of fluid for the brakes. The hose on the brake ...