Questions & Answers for: Mini bleed coolant

...coolant is circulated constantly, and can go through the heater matrix if the heater control valve is open. It is more likely that the control link to this valve has come off or needs looking at. It ...

...bleed the cooling system.i do this through the coolant resevroir. this is important, or else ur vehicle is going to overheat and boil over no matter if the system is full or not. there are 2 coolant ...

...bleed the system. Let me know if you have more questions. If the radiator is filled to the top with coolant and the engine is run without the radiator cap in place, the coolant will expand and spill ...

...coolant level which is ok, but it does need to be topped up Top it up but also bleed the system. With the car running, open each bleed port you can find and let any air out. I know there is a port on ...

...bleed screw on pipe above fan belt. Fill coolant via pressure cap ( right had side of engine....not expansion bottle) tighten once coolant free of air is seen. Run engine, loosen other plastic bleed ...

...bleed screw. Then tighten it up, top up coolant, replace cap, fill expansion tank to level. Sit in car and hold revs at 2000 rpm for 2 minutes with fan on and heat at maximum. If it dont feel like a ...

...change water pump change the Rad. change the blend door motor flush the block bleed the system add new green coolant. After all that still blowing cool air at Idle. What is causing this

...common cause of overheating is a gradual loss of coolant from the thermostat housing seal. You need to top up and bleed the system and arrange to have the thermostat housing checked /

...of videos that may help if someone wants to have a go changing the pump, thermostat as well as bleeding

...cooling system when refilling the system with coolant?There is a refill procedure which requires bleeding air from the cooling system when refilling a 2005 Montana. Also,when a new thermostat is ...