Questions & Answers for: blade tension Cars & Trucks

tension clamps. If replacement is necessary, use only an original equipment clamp with matching number or letter. If water pump is being replaced, do not unbolt fan blade assembly from thermal viscous

...blade. Check the spring tension on the wiper arm as well and the shoulder pin connecting it to the wiper motor to see if it is loose. If it is much looser than the passenger side, then put in a new ...

...blade. What's next? Get a replacement tension spring from the dealer. This spring is visible when you flip the wiper arm into the up position. Seems as though your tension spring may be weak which ...

...the belt out from around all of the engine accessory pulleys. Pull the belt around each of the fan blades and up out of the engine compartment. Slide the new belt around each of the fan blades and ...

tension from the belt. Then, pull the belt off the top of the tensioner pulley. Release the tensioner pulley and pull the breaker bar off the pulley bolt. 4 Pull the belt out of the accessory pulleys.

...tension from the belt. Pull the belt out from under the pulley and slowly let the breaker bar retract.5Remove the accessory belt from each pulley with your hands. Rotate one of the fan blades to the ...

...or the proper way to adjust the tension. I've been having hard times also putting right tension on my Haltbar blade . Try reading this blog : http://bandsawblog.com/blade-tension/ Hope that

...fit around the blade and sprocket. Is this the right chain or is there some other issue? Thanks Release the tension on the blade tensioner by turning the screw. I had the same problem with my ...

...not. The arms and blades are replaced as a unit. This will ensure that the tension on blade is correct. ...

...tension from the belt. Pull the belt out from under the pulley and slowly let the breaker bar retract. Step 5 Remove the accessory belt from each pulley with your hands. Rotate one of the fan blades ...