Question about Consumer Products Backpack Blower/Vac, Carb
...nose pliars, 1/8 turn at a time. They are very tight. Then I cut the slots with a fine hacksaw blade and re-installed them. BEFORE you begin, MARK where the "pointer" notch is on each screw so ...
Question about Consumer Products Backpack Blower/Vac, Carb
...Thanks. I would remove the chain and give the guide channel a good cleaning. Use a small blade screwdriver to clean all debris and old bar oil and sawdust. I spray mine down thourghly with ...
Question about Consumer Products Backpack Blower/Vac, Carb
...gasket and diaphragm kit installed to restore it. It may also need a few small adjustments of the Low and High speed mixtures screws. A lot of different things can cause these machines to function ...
Question about Consumer Products Backpack Blower/Vac, Carb
...in the pull cord fin to stop shaft). Then remove spring around rubber gasket behind blade (then rubber gasket pulls off shaft. everything else just UN-bolts. Just figured it out myself
Usually answered in minutes!
778 Questions
175 Questions
129 Questions
92 Questions
66 Questions