Question about 7901-1 ProHeat Scotchgard Upright Wet/Dry Vacuum
...Repair_Guide.pdf dont replace the whole pump just the red thing When removing the six screws on the black cover that shrouds the innerworkings. Be careful that the flow indicator lid is unscrewed,and ...
...black the small tube near the heater. Take apart the handle and the run a small screwdriver or pipe cleaner through to unblock the small tubes, put it back together and it will be like new. I had the ...
Question about Vacuum - Momentum Cyclonic 1 ea Bagless Upright Vacuum
...vacuum has an air flow indicator. I thought it only had green and red but now I seem to be getting black and its not working very well. I have checked all the hoses and tubes the best that I can and ...
...tube on the far side of the switch on the handle - where the water actually sprays out of. If water runs through those parts fine, then they are clear and the blockage is elsewhere. If that doesn't ...
Question about 9200 Upright Vacuum
...tube leading into cleaner solution but didn't help. There are a couple areas to check: 1. The black gasket where clearview water collecting unit and the base's front meet. Ensure gasket is in good ...
...thanks. It sounds like one of the internal tubes is loose or has a leak. You'll need to open up the black plate (the plate where you place the water tank on top of). Inside there, you'll be able to ...
black plastic tube with two clear tubes attached. Remove the two tubes. remove the screw holding the black plastic tube in. Inside is a red gasket. Ensure that is in the correct place. Reattach screw
Question about 8910 ProHeat Clear View Upright Vacuum
I am putting my bissel 8910 back together and behind the motor there is a black 3-way tubing connector. One side goes to the pump discharge, one side goes to a tubing going to the right rear wheel ...
Question about 1716 Spot Lifter PowerBrush Bagless Handheld Vacuum
...tube has become disconnected from the outlet fitting on the inside of the solution tank. If so, you need to buy a replacement solution tank. Parts can be found at www.bissell.com 5) Check to see if ...
...and the Formula Bottle to make sure each has a red (or black) auto-load gasket attached and facing outwards and that the ventilation tube is not submerged as it allows air in so the solution can
Usually answered in minutes!
432 Questions
390 Questions
261 Questions
302 Questions