...black piece of metal at the rear end of the clipper blade whilst on the clippers, simply push this in towards the blade and at the same time pull the front edge of the blade away from the clipper to ...
...black metal which i think is called the blade lock latch which you push up to release the blade, hangs down from underneath the silver metal tonge on which the blade is fitted, if you push it up it ...
...metal plate goes on first then the black latch will connect to the hinge, there are two small holes either side of the latch where two spring ends poke through then simply screw it back on, not sure ...
Question about AGC2 Hair Trimmer
2 by mistake,how do i fit back together it doesnt seem to fit Instructions come in with a new drive assembly, basicly put the black end through under the metal frame first then push it down into place
...blades from a AGC2 hair trimmer If you look at the base of the blade at the bottom edge the is a black metal bar, push this in towards the blade and pull the nose of the blade away from the
Usually answered in minutes!
65 Questions
52 Questions
58 Questions
31 Questions
25 Questions