Questions & Answers for: Hayward black line

black plastic piece on the terminal block(jumper). That arrow lines up with either the 115 or 230 mark on the white terminal board. Make sure it is aligned with the 115. Then put you two line wires on

how do you get the black quick release ring to work correctly, it doesn't line up right and very hard to turn to correct spot im sorry not sure what are you taking about

...Black ) wire It the line terminal the hot (i.e. Black ) wire If I read your question as "Is the black wire the 'hot' line" then yes, it would be, IF your line leads are wired to code and we are ...

...line is L1 white and L2 black Shouldn't be a white line on a 220 circuit but some people use them. Red and Black is the standard. If you are sure they supply 220 VAC, which I would verify, it doesn't ...

line. I can see where the white and one black wire go but where does the other black wire go? Other terminals on the motor are marked A and B. I WOULD THINK THAT THE WHITE WIRE IS GROUND AND THE OTHER

...black go to l 1, white to l 2 Sure...you can actually hook either wire to either line terminal. Be sure you have the voltage selector set for the incoming line voltage your circuit will be supplying ...

...line lead wire to the L2 terminal and the green ground wire to the green grounded screw above the motor terminal board. It does not matter which wire, white or black, is on which terminal, L1 or L2, ...

...internal wire connected) ; Line 2 --> L2 (with black internal wire connected) I'm not sure if the black wire is correct for the 230v operation.... don't mater its ac there is no ...

line 1, black wire. I have 121v at line 2, white wire, & my meter was connected to the ground screw, bare copper wire Are you getting about 240v between L1 and L2? Regardless the motor shaft should be

...line - checked configuration (plug aligned to 115v) - Wired (White -> L1 , Black-> L2 (terminal 3) Plug black -> L2 Term.4 White -> A terminal Checked and cleaned all grounds, and put in a new ...