engine cuts out when i put my bike in gear it cuts out your clutch is draging adjust the clutch cable so that when you are on the bike with the bike off and in gear and clutch pulled in you can move ...
wont start it was fine until the other day and now it jus wont start. any information would be a great help Yup, needle valve. Even a spec of sand can cause this. Take it apart and clean or replace it
...the bottom hex nut on a 1990 kz 125 to get at the fork oil seals? General intructions for most bikes: Remove front wheel. Loosen fork tube clamps at top and bottom of triple clamps. Slide fork ...
...bike wont fire upi have cleaned carb took head off cheacked piston &rings they are fine but bike does not fire at all Even tho u have got a spark dose not mean the spark plug is ok try changing ...
...wont fire up bike has a spark but wont fire up i have cleaned carb out took off the head cheacked piston&rings they are ok but still wont fire at all Have you checked the engine earth from the ...
...apart from removing the lights you wont turn it into a MX bike, new expantion chamber,porting and suspension mods are all quite expensive, just try and learn as much as you can as it is(minus
not have enough compression to turn over i would suggest getting a compression test done at a local bike shop. If thats the case it most likely needs rebuilt
...bike wont rev up could anyone shed any light as to what i am doing wrong thanks. sounds like a double earth/live wiring loom some bikes have 2 black wires bolted to the frame 1 is earth and the other ...
...bike wont run just backfires after every 4th or 5 th kick KICK HARDER TRY PULL STARTING IT..IN SECOND GEAR..DOES IT HAVE ENOUGH COMPRESSION TO START?IT SHOULD START PULLING IT...START OFF WITH NO ...
...bike just had a rebuild and was cutting out so I tried tuning the carb with little knowledge and think I messed it up abit now it wont start so I need to now the standard setting for the carb of a ...
Usually answered in minutes!
19 Questions
7 Questions