Questions & Answers for: Buell bike frames measured

...of the seat. Once the rear of the seat is lifted continue to pull the seat toward the rear of the bike to free it from the

...whats wrong. Please think about these symptoms and let me know what you think is busted. when the bike warms up it frys the ignition fuse and dies. Also when the bike is just sitting idleing the ...

shifts 1st second wont go to third shifts 1st second wont go t third The bike has a bent shift fork. The engine comes out of the frame and gets a complete teardown.

...It could be a shorted voltage regulator. Sometimes they will short and draw current even when the bike is not running. I would measure the current drain with an amp meter by removing a battery

2004 Lightning XB9S: hello, my problem with my bike is Yesterday, i... Hellomy problem with my bike is yesterday i drove my bike close to my house the bike suddendly stoped just before the trottle ...

...bike Try looking over at Badweatherbikers.com, and if you don't find what you need ask in the old school Buell (tube frames) section. My Buell is a firebolt so that's the best advice I can give you ...

... popping the fuse. Check the wiring underneath the ignition switch and where the wiring follows the bike frame to the starter, to see if a worn spot exists, or if some other form of contact between ...

...the question of fitting the fuel tank back on the Buell M2 Cyclone 2001.the tank has been off the bike for approximately 6 weeks and now will not go far enough forward to let the tank sit back down ...

08, 1125r...Just bought it. On my first ride i noticed gas drips from tube on the back of bike opposite side from exhaust. I assume this is an overflow tube but it drips gas for 15 minutes after every

Buell Blast 2000 -problem starting the bike - I have a Buell Blast 2000 with 12k miles, purchased it last year. I have no problem starting the bike when it's cold, but after i ride it for ...