...and rubbing alcohol.) I don't have much experience with this specific calculator but those are my best bets. good luck ...
...both the spindle and the hole (motor) with a q-tip. The hole is smaller than the q-tip, but do the best you can to remove the old lubricant. Get a bit of WD40 and lubricate the spindle and spray a ...
...best bet is to either let it set unplugged for a day or two in hopes it will dry out, or unplug it, remove the control panel and dry it out with a hair dryer (but not too close - don't want to melt ...
...tips or ideas for this hell? -Thankx Klaus Usually the torque spec for those nuts is pretty high, and they suffer from what I call "environmental torque" as well (exposure to the elements and to heat ...
best way to go about finding the misfire would be to go to an auto zone or other auto parts store that will scan the computer for codes. the codes will tell you which cylinder is misfiring.I would bet
Question about 5965 Electric Kettle
day to be safe), make sure it's still unplugged and check the contacts in the base center for corrosion (there's the center ground pin and if you push down on it's spring-loaded ring around the ground
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions