Bernina 830 stuck My 1981 Bernina 830 was serviced, then stored for a year. Today I found it is stuck. The motor works but the needle doesn't move. It filled a bobbin just fine. Suggestions? Okay, my ...
...bernina 830 stitching problem: tight old bernina 830 stitching problem: tight understitch loopy overstitch Sounds like you need to adjust the tension. Probably a good idea to oil this older machine ...
Bernina 830 Sewing Machine is not sewing the 1-20 stitches, only straight stitches. If you are selecting patterns but only getting a straight stitch after making sure you have set the width, there may
Bernina 830 - I got a pin stuck in the feed dog. The pin is out now but the feed dog has been moved such that it does not feet the fabric. It does not come out far enough. Can I adjust it myself? Take
Question about Artista 180
...830 Bernina When I try to tighten the hoop with the knob, it won't turn and I don't want to break it. Use a pair of small pipe grips and hold the pulley wheel at the same time it wont be that tight. ...
Question about Artista 180
...bernina 830, please help I am out of commission until 8 get this back together! ! I have the original machine manual but that doesn't go into the wiring of course! I had to replace the foot with one ...
Question about Artista 180
...you how to oil it. My machine Bernina 830 does not run Bernina 830 won zig zag won buttonhole no decorative stitch Bernina 930 Record oiling diagram Questions Answers for Bernina seized Sewing ...
Question about Artista 180
...Bernina 830 Record (older mechanical model), it is usually the very bottom knob on the right side (directly below the Stitch Length Lever). It should turn right or left about a quarter turn to switch ...
Question about Artista 180
...830 bernina Bernina 830 Record??? Or newer Bernina 830 computerized?
If it's a Record, could very well need a good cleaning and oiling. Older mechanical machines need periodic lube to keep ...
Question about Artista 180
...Bernina 830 (computerized. The needle is stuck in the far right position and the needle threader won't lower when I try to thread the needle. Is there a fix? Problem occurred when I accidentally ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions