Questions & Answers for: Chrysler belt sensor

...you checked the belts, did you mean the timing belt? A broken timing belt could cause it to die and send a cam sensor code. You might want to check that if you haven't before towing it to the

...on marks.need help when you broke the belt you most likely broke the magnet for the cam sensor. What you need to do is spin the engine around to TDC and look for a magnet. Take the sensor out

seat belt sensor on the passenger seat does not go off Hey, take a look at www.airbagmodul.com They're working in Airbag-Simulators, Occupancy Sensor-Simulators and Seat Belt-Sensors. Regards Gerrit

...sensor and stuff did you check to see if the timing belt was still intact? Do a compression check to see if you've lost compression on any cylinders. If the timing belt broke this will be the case. ...

...sensor in the timing belt housing and push down until contact is made with the camshaft sprocket. While holding down in position, install and tighten bolt to 12 N.m(105in.lbs) torque. Hook up ...

replaced timing belt and wont start code scanner reads crank and camshaft sensors are failing .Is the timing off or is the sensors bad .ran great before chaging the belt at scheduled maintenance time ...

come on the dash board, even tough you have the seat belt on, what am I to do? sensor on the seat belt fastener bad. Wiggle it to make it go off with the seat belt locked in place or change the sensor

...sensor. If the signal appears normal, then check the timing chain/belt for proper alignment. If it's misaligned, check for a damaged tensioner that may have allowed the chain/belt to slip a tooth ...

...the timing belt?? If not the problem is likely to be a loose worn out timing belt. A floppy belt will play havoc with the sensor signals and trigger a check engine light and a camshaft sensor

...belt, new cam shaft position sensor and magnet, crankshaft position sensor, and engine coolant temp sensor on. first after putting the belt on it came up engine coolant temp sensor changed it, still ...