beater bar won't turn If you hear the motor in the head running and the beater bar isn't rotating, you probably need a drive belt. With the power off, make sure you can rotate the beater bar freely by
...beater bar side up. Locate the catches or screws that hold the plate on that covers the beater bar. Remove the plate. The beater bar sits in sockets where it attaches to the vacuum, so remove ...
...beater bar side up. Remove the cover base plate that surrounds your beater bar. It's held on with either clips or screws, and usually "hinges" toward the front of the vacuum to release when the ...
...beater bar up, and remove the plate that surrounds the beater bar. The beater bar needs to come out next. If the belt is good, it will be a little hard to remove. The beater bar sits in sockets that ...
Question about EL8502 Versatility Bagless Upright Vacuum
...beater bar has seized. 1. Turn off the power (unplug). 2. Remove the bottom plate. With the plate off, use your finger to test the tension of the belt. It should be tight, and roll when you roll the ...
...beater bar by gripping the belt side of the beater bar and carefully lifting it out. • Remove worn or broken belt. • Clean beater bar and the end caps. • Loop new belt around motor shaft and beater ...
Question about Mc-Ul594 Eco Max - Bagless Upright Cleaner
beater bar that needed to be replaced. My beater bar has stopped working and I have tried all the normal causes; reset button, trying the beater bar with each segmant of the wand. Is there a fuse? and
Question about Mc-Ul594 Eco Max - Bagless Upright Cleaner
...beater bar brush. Turn it over and use a screwdriver or knife, and run it the full width of the beater bar to remove the hair and string and other debris that get wound up on the beater bar-NOTE you ...
Question about Mc-Ul594 Eco Max - Bagless Upright Cleaner
...beater bar belt or the motor shaft belt? If so, you need to set the vacuum in a horizontal configuration and turn the vacuum upside down. Next remove the five screws from the base plate and lift the ...
beater bar switch on the top of the unit next to the on/off button does turn the green light on/off as it should, and the bar will turn(with a bit of resistance) by hand. (& yes I have tipped the body
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions