bat. you are going to have to work in tight places with your hands. I cannot remember which hose is which, but there is a easy way to findout, do the connections at the pump have clamps and the othter
...to the coils if no power check ign fuses manly ign 1 fuse if you have power then hook test light to bat positive and check for grounding pulse on the other wire at each coil if it is pulseing while ...
...bat was flat so jumped it started dove home left running for 15 mins try charge battery but batt was knackered so bought new one as soon as i put it in car turns as if it wants to start check engine ...
bat) and it will be 12.6vdc (warm day) if not i charge it. i then hot wire the starter solenoid. (cuts diagnostic work in 1/2) I put car in park, or neutral if ,M/T then chock the tires/wheels (safety
...left, black shinny paint? http://www.fixkick.com/engine/97-motor-pull/HTML/image_50.html less intake man. fresh motor install. PS.the starter is bad if hot wiring the solenoid fails. (charged
...bat goes hot ,12v, if the switch on the lower left is bad (shorted) this is the SUSTAIN switch. pin 3 wiper off is 0v. if pin 3 is 12vdc wiper off(again key on) then the switch lower left is shorted ...
Question about 1994 Prizm
...bat man. posted same questions over and over!!!! did you check fuses first? and do the CLUSTER self test. i posted that on your last post and all jeep dealer sell parts, is this a revelation? did you ...
Question about 1994 Prizm
...man job. fuse 9, hot both sides. and is hot all the time bat side. brake switch LG/R wire hot all the time key off too. light green red ! step on brake R/LG goes hot, now. if not switch is ...
Question about 1994 Prizm
...bat, gee. bad axle bearing , I just fixed, 5 years ago. the microphone (my tool) clamped to axle 3 places, 4 channels mic. left rear , center and right rear the right is 10x louder. so I , remove the ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions