Questions & Answers for: Ford Mustang balance shaft

...balance drive shaft or suspension components are shot. Thoroughly check each bushing, ball joint and tie-rod end to make sure they are not worn. Also make sure it's not an out of balance tire or bad ...

... my 2000 mustang 3.8 also had a bad vibration. after many trial and errors we replaced the harmonic balancer..not too hard but requires the "special" tools...and you have to buy it from the ...

...order be sure to mark the drive shaft position so it is re-assembled in the same location, it's balanced at the factory. Also Locktite the driveshaft mouting bolts and torque them. (42-57 FT

...shaft sensor and/or crankshaft sensor. Also ensure the harmonic balancer is in good condition and is not cracked, or any rubber (if installed) is not broken or any chunks are missing. These can throw ...

...shaft, I put the rear u-joint into the axle slightly off-center. It would shake rather badly at about 45 MPH, but was mostly smooth above 50 or below 40. I thought it was a wheel balance problem, but ...

...Requires two people or a special momentary contact bump switch. Find the TDC mark on the harmonic balancer. Clean it off if necessary so you can see it easily.Remove the #1 spark plug and place

...valve has opened and closed, the intake valve should open and close. At that point watch the crank balancer for the "timing" marks to line up. Then install the distributor with the cap OFF, watching ...

...the clutch pedal as well. Was the Flywheel Machined? Was the Flywheel Balanced? Was the Balanced Flywheel & New Clutch Assy bolted up & Balanced together? Have to Balance Drive Shaft ...

...and vibration between 30 and 60 mph , replaced rear end and now no noise but still vibration . balanced drive shaft , still bad vibration .. removed drive shaft and drove on lift without shaft ...

...shaft joints Check or replace ALL motor & trans mounts & check any rear axle suspension bushings Standard Trans have issues that require a lot more work to diagnose & find a problem, than ...