...shaft sensor? If so then it is on the front of the engine on the lower timing cover behind the balancer. Good ...
Crank shaft position sensor I can't find the crank shaft position sensor on my truck. it should be behind the harmonic balancer at the driver side , front of the oil pan
...rope.All weight swings to the same side at the same time,rather than being off set.I usualy have it balanced at the same time as I replace the U-Joints.Well just my two cents.Hope it helps and good ...
Replaced U-Joints and had vibration ,had driveshaft balanced and still vibration 45MPH on up. 2000 1500 extend cab 4 4 8'bed 2-piece drive shaft with carrier bearing, any ideals also fan switch speeds
...wheel and 4x4 shifter shake very bad at 50mph. It has had a new transfer case put in, driveshaft balanced and all four tires checked. The vibration goes away if you take your foot off the gas.
shaking from the rear of truck u-joint? bad u joint or drive shaft has lost a balancing weight. either should be visible without tools
...If it is not marked is there a way to know how to put it back in right or will I have to get it rebalanced? have it checked, a reputable mechanic will not charge you if it does not need
Question about 1999 Silverado 1500
...balance weight from the tail shaft. To check uni joints look for rust streaks from cross.The next step is to grab firmly either side of the joint and see if there is any movement while twisting you ...
...Excessive Fix a flat in tire,,, bent rim,,, bent drive shaft,, or bad u joint,, Can you feel the shaking on the steering wheel? Weights coming off throwing the balance off can also cause
Question about 2007 Silverado 1500 2WD
...shaft out of balance,have had a new drive shaft installed and now does it at a lower speed on a 2014 silverado 1500 on a 5.3 eng. any help Did you have new u-joints installed CORRECTLY... the drive ...
Usually answered in minutes!
4,236 Questions
159 Questions
130 Questions
67 Questions
56 Questions