Questions & Answers for: Mitsubishi Eclipse bad connection

...bad connection to starter, or - bad connection(s) on starter relay, or - low charge on battery, and - and maybe some others... but these are most likely how do i change the timing belt on a 1995 2.0 ...

and corosion. If they are O.K. then its a lazy (worn) starter motor check the connections. put the headlights on and then check and wiggle connections, if the lights flicker, you have a bad connection

...bad connection between your starter relay and starter. Check your connection at the battery post, the starter relay and the cable for the starter. Loosen and re-tighten these. It could be a simple ...

...bad connection. If you fix this problem, or if the car will start now, and you still have problems with the window, you might have a bad motor, or possibly broken wire in the door area. It's hard to ...

...Also check the PCV hose and connections.  It could look fine, but it does not take much for a bad hose/connection to foul the PCV function.  It will blow smoke out the tailpipe

...keep flashing on and off everytime i open the door or start the car Must be bad switch or bad connection. Did it happen before months ago then it's ok fir that car. Could be lock and unlock

my eclipse will start with cam position sensor disconnected and run for a minute badly but wont with it connected could be a bad sensor but im not 100% sure

...connected ...If they are not this will cause a misfire and it will shake and vibrate...wires can go bad and still look good so if nothing is evident to be bad an engine scanner will help very ...

...grind going into first gear? Your slave cylinder in your ****** or your master cylinder could be bad. Both are integral parts of your transmission. The master cylinder is a hydralic hose that goes ...

...-egr valve 3 most common nonstart than start again problem --also check for power to plugs bad wire or connection could cause nonstart ---if it didnt turn over check connections on battery or ...