...of a defective battery or defective battery cable connections,. battery flat or battery need replacing either you got a bad battery connection or a bad starter solenoid or your engine is locked ...
Question about 2007 Sorento LX 4x4
...connection is sending bad information to the computer and it is setting the fuel / timing badly to try and compensate for the bad signal. Could be a bad computer too.Try taking the car to a local ...
bad connection issue i have an obd2 scan tool and when i hook it up to my 20 dlc darn thing keeps telling me i have a bad connection at the dlc i used a test light and one wire shows power and the the
...Bad connection at the battery. As soon as large current is demanded by the starter, you lose the connection. Make sure both terminal connections on battery are clean and tight. Now is a good time to ...
Engine not turning over Low battery, starter, solenoid, dirty connections to starter of solenoid, bad connection on LT leads to solenoid, seriously bad earth on battery, solenoid.
Question about 2005 Amanti
...wash down--rain loose connections --not properly connected broken wires --excessive engine movement bad ground connections ---battery ground lead --dirty terminals failing battery---have a load test ...
Question about 2005 Amanti
My kia rio2014 rpm needle going up and down contineusely what happen? May be bad tps or vacuum leak...any codes? Crank sensor or speed sensor may be going bad or have a bad connection.
Question about 2005 Amanti
...p0600 and car stuck in limp mode speedometer n odometer don't work n light don't come on That means the computers have quit talking to each other, could be a bad cable, bad connection or bad
Question about 2005 Amanti
supply is bad. Howevr the ignition coil or its connection cud b bad Possible crank shaft sensor or its wiring/connection is bad . Does the tachometer, if equipped, register while cranking engine over
Question about 2005 Amanti
...position relearn? If this procedure was done and still failing then likely an intermittent circuit fault (broken wire, bad connection, etc.). If relearn was not executed then it's a more likely
Usually answered in minutes!
1,074 Questions
1,065 Questions
1,058 Questions
1,036 Questions
974 Questions